Sub-Zero ID-24R Integrated Installation Guide - Page 12

PANEL INSTALLATION Panel Installation DOOR PANEL INSTALLATION Typical panel dimensions are based on an 84" (2134) finished height with 1/8" (3) reveals. Template placement must be adjusted for panels exceeding typical dimensions. For tall models, the door panel should be installed first, followed by the upper then lower drawer panel. Place the panel face down on a protected work surface. Position the template flush with the top and sides of the panel. Verify the correct side of the template is being used, then mark and drill holes. Refer to the illustration below. For tall models, align the notch in the template with the bottom of the door panel, then mark and drill holes. Refer to the illustration below. Use the T-20 torx drive provided, to partially insert a #8 x 1/2" screw into the second hole from the top on each side of the panel. The screws should be approximately 3/16" (4) proud of the panel and will support the weight of the panel during installation. Align the support screws on the back of the panel with the slotted holes on both door mounting brackets. Opening the door slightly may help with alignment. Once the panel is supported by the screws, partially insert a #8 x 1/2" screw into the second hole from the bottom on each side of the panel, but do not tighten. CAUTION As the reveal between cabinets and the unit decreases, the potential exists for severe finger pinching if fingers are placed in the opening when the door is closing. TOP OF DOOR PANEL TOP OF DOOR PANEL 84" APPLICATION 83 7/8" ACTUAL BOTTOM OF DOOR PANEL USE TABS FOR HINGE SIDE PANEL EDGE ON DUAL INSTALLATION BOTTOM OF DOOR PANEL BOTTOM OF DOOR PANEL BACK OF DOOR PANEL TOP OF DOOR PANEL 84" APPLICATION 83 7/8" ACTUAL USE TABS FOR HINGE SIDE PANEL EDGE ON DUAL INSTALLATION Door panel template-top. Door panel template-bottom (tall models only). Door panel mounting. 12 | Sub-Zero Customer Care 800.222.7820