Sub-Zero ID-30CI Integrated Installation Guide - Page 8
Placement, Alignment
View all Sub-Zero ID-30CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INSTALLATION Placement CAUTION Before moving the unit into position, secure the door/ drawers closed and protect any finished flooring. Use an appliance dolly to move the unit near the opening. The front leveling legs are extended below the front rollers to improve stability during placement. Once the unit is placed in front of the opening, completely retract the front leveling legs to allow the unit to be rolled into position. Front and rear leveling legs can be adjusted from the front once the unit is positioned. If the unit has been on its back or side, it must stand upright for a minimum of 24 hours before connecting power. Plug the power cord into the grounded outlet and roll the unit into position. Verify the anti-tip bracket is properly engaged. Alignment LEVELING Once the unit is in position, height adjustment can be made from the front. Using a Phillips drive, turn clockwise to raise the unit or counterclockwise to lower. Use the lowest torque setting when using a power drill. Do not turn the leveling legs by hand. Refer to the illustrations below. When the unit is properly leveled, door/drawer adjustments are less likely to be necessary. IMPORTANT NOTE: Level the unit to the floor, not surrounding cabinetry. This could affect the operation of the unit, such as door closing. WARNING To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor. FRONT LEG ADJUSTMENT REAR LEG ADJUSTMENT Front adjustment. Rear adjustment. 8 | Sub-Zero Customer Care 800.222.7820