Sub-Zero UC-24R Undercounter Installation Guide - Page 12
Undercounter Installation, Hinge Adjustment, Overlay Panel Installation - parts
View all Sub-Zero UC-24R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Undercounter Installation 12 Overlay Panel Installation The model UC-24BG glass door is made with a sealed, double-wall tempered glass core. The drill must not contact this core when drilling. Be sure the hole is centered on the small groove in the front of the door frame and the drill passes squarely through the frame. If you are inexperienced with drilling, fasten the handle from the rear of the door panel only. Hinge Adjustment IMPORTANT NOTE: The undercounter unit should be properly leveled before door hinge adjustments are made. The top and bottom cabinet hinges are held in place with three permanent adjustment screws. If the door needs adjustment, loosen the adjustment screws and reposition the door. Once in position, tighten the adjustment screws. Refer to the illustrations below. IMPORTANT NOTE: For model UC-24BG, install screws in all the mounting holes in the door frame. The nature of the door panel with a narrow outer rim and no connecting center member requires the support provided by the glass door. After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door. TOP DOOR HINGE ADJUSTMENT SCREWS BOTTOM DOOR HINGE ADJUSTMENT SCREWS The cover patches or plugs are part of the insulation system on the door of the undercounter unit. Be sure to cover all the holes in the door that were used. Top hinge adjustment. Bottom hinge adjustment.