Sub-Zero UC-24RO Undercounter Installation Guide - Page 6
Site Preparation, Plumbing Requirements, Electrical Requirements
View all Sub-Zero UC-24RO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Site Preparation 6 Electrical Requirements The electrical supply should be located within the shaded area shown in the illustration below. Follow the National Electrical Code and local codes and ordinances when installing the receptacle. A separate circuit, servicing only this appliance is required. IMPORTANT NOTE: The electrical outlet must be placed so the grounding prong is to the right of the thinner blades. The outlet must be flush with the back wall. Model UC-24RO is designed and safe for use in outdoor applications. When installed outdoors, a ground fault circuit interrupter (GFCI) is required to reduce the risk of electrical shock. A GFCI is not recommended for use with other undercounter models and may cause interruption of operation. Do not use an extension cord or two-prong adapter. Electrical ground is required on this appliance. Electrical Requirements Power Supply Circuit Breaker Receptacle 115 V AC, 60 Hz 15 amp 3-prong grounding-type Plumbing Requirements MODEL UC-24CI For model UC-24CI, the water supply line for the ice maker should be located within the shaded area shown in the illustration below. Connect the water line from the ice maker water valve to the house water supply line. Use an easily accessible shut-off valve between the water supply and the unit. Do not use self-piercing valves. A saddle valve kit is available from your authorized Sub-Zero dealer. A line filter is required when water conditions have a high sediment content. The ice maker operates on water pressure of 20 psi (1.4 bar) to 100 psi (6.9 bar). A reverse osmosis system can be used, provided there is a consistent water pressure of 20 psi (1.4 bar) to 100 psi (6.9 bar) supplied to the water valve at all times. A copper line is not recommended for this application. IMPORTANT NOTE: In some cases a reverse osmosis water filter system may not be able to maintain the minimum water pressure consistently. Plumbing Requirements Water Supply Line 1/4" OD copper, braided stainless steel or PEX tubing Water Pressure 20-100 psi (1.4-6.9 bar) Excess Water Line for Connection 26" (660) min LEFT SIDE OF OPENING 2" (51) 151/2" (394) 3" (76) FRONT VIEW Location of electrical supply. SHADED AREA EXTENDS 1/2" (13) FROM BACK WALL 2" (51) 151/2" (394) 3" (76) FRONT VIEW Location of water supply.