Symphonic RSMSD513E Owner's Manual - Page 10

PREPARATION FOR USE ANTENNA/CABLE CONNECTIONS From Cable System or Satellite Dish Satellite Box or Cable Box OUT (Not supplied) IN Rod Antenna (Supplied) VHF/UHF Antenna (Not supplied) VHF Antenna (Not supplied) From Cable System UHF Antenna or (Not supplied) 75-ohm Coaxial or Cable (Not supplied) ANT. COAXIAL VHF/UHF or Combiner (Not supplied) ANT. or Flat twin-lead cable [Fig. 4] Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. NOTE: Before plugging the antenna into the ANT. IN jack of the TV/DVD, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. IN jack of the TV/DVD. Bent pin Cable Plug (Needs to be straightened)(Straight pin) VHF/UHF COMBINED ANTENNA The VHF/UHF Rod Antenna (supplied) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TV/DVD. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. terminal of the TV/DVD as shown in the diagram above. For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.) VHF/UHF SEPARATE ANTENNAS In some areas it will be necessary to use an outdoor antenna. CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX Use this connection if your cable system connects directly to your TV/DVD without a converter box. Use the TV/ DVD Remote Control to select channels. CABLE WITH CONVERTER/DESCRAMBLER BOX OR SATELLITE BOX If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here. Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/ DVD Remote Control. TO VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL 1.Set the TV/DVD channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3) 2.Select the channel to view on your Cable Converter Box or Satellite Box. - 10 - EN 0C28