TASCAM TRACKPACK 4x4 Software/Firmware Update procedures - Page 4
Updating the firmware
View all TASCAM TRACKPACK 4x4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
US-2x2/US-4x4 Updating the firmware For Windows 1. Double-click the "US-2x2_US-4x4_FirmwareUpdater_XXX. exe" execution file prepared before to start the updater ("XXX" is the firmware version) . 4. When the unit is recognized, the Download button on the right will become enabled. Click the Download button to start the firmware update. 2. Click the Connect button on the updater screen. 3. Confirm that "Device" shows the model name of the connected unit. In addition, the "Firmware Version" should show the current version. CAUTION During the update, do not disconnect the AC adapter or the USB cable or turn the computer off. Doing so could damage the firmware and the update might not be able to operate properly. 5. When the firmware update completes, the following screen appears. 6. This completes the update. Click the right to close the window. button at the top NOTE • If the current firmware version shown by the updater is the same as the latest version, there is no need to update. In this case, click the button to close the updater. • If the unit and computer are not connected, "Error. No Device found" will appear. If this happens, check the following. • Confirm that the power is on • Confirm that the unit and the computer are connected by a USB cable • Confirm that the USB indicator on the unit is lit 7. After the update completes, you must turn the unit off once and on again before it can be used. To use a US-2x2 powered by USB bus power, disconnect the USB cable once and reconnect it again. To use a US-2x2 powered by an AC adapter (sold separately) or to use a US-4x4, disconnect the AC adapter cable from the unit once and then reconnect it. 4 TASCAM US-2x2/US-4x4