TASCAM TRACKPACK iXR Firmware update procedures - Page 2

iXR 3. The current firmware version is shown under "From" and the update version is shown under "To". 4. Click the "OK" button to start the firmware update. CAUTION During the update, do not disconnect the USB 2.0 cable or turn the computer off. Doing so could damage the firmware and the update might not be able to operate properly. 5. When the firmware update completes, the following screen appears. NOTE ii Updating is not possible if the current firmware version and the latest firmware version shown by the updater are the same. In this case, click the button to close the updater. ii If the unit and computer are not connected, "Supported hardware is not connected." will appear. If this happens, check the following. • Confirm that the unit and the computer are connected using a USB 2.0 cable. • Confirm that the USB indicator on the unit is lit For Mac Downloading the firmware updater Download the firmware updater (as a ZIP file) for the operating system you are using from the TEAC Global Site (http://teac-global.com/) and save it on the computer. NOTE Depending on the computer's settings, the downloaded ZIP file might not have opened automatically. In this case, unzip the ZIP file to access the disk image file. Connecting 00Use a USB 2.0 cable to connect the unit and the computer. 00Confirm that the USB indicator on the unit is lit. 6. This completes the update. Click the right to close the window. button at the top 7. After updating completes, you must turn the unit off and on again once before using it. Updating the firmware 1. Double-click the disk image file that you just downloaded. 2. Double-click "ixr_firmware" in the opened folder to launch the firmware updater. 3. Click the "Firmware Update" button on the updater screen. 2 TASCAM iXR