TASCAM X-17 Owners Manual - Page 8
How to replace the cross-fader, Rear Panel
View all TASCAM X-17 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English Features and controls b OUT key Stops sample recording or playback. When the SAMPLER SOURCE selector is set to SAVE, this key saves the X-17's internal sample data to the CompactFlash card. n MONO SPLIT switch and indicator Selects headphone monitoring mode: either MONO SPLIT mode (the indicator is lit) or STEREO mode (the indicator is unlit). STEREO mode: You monitor the CUE signal and MASTER signal as determined by the PAN control. MONO SPLIT: You monitor the CUE signals in mono from the left headphone, and the MASTER signal in mono from the right headphone. m Monitor MIX Adjusts the balance in the headphones between the CUE signal and the MASTER signal. , PHONES LEVEL Adjusts level of the signals output through the headphones. . PHONES Connect a standard pair of stereo headphones to this 1/4" jack. How to replace the cross-fader 1. Move the fader to the top and remove the fader knob. 2. Remove the two screws retaining the fader. 3. Remove the fader. 4. Unplug the multiway connector connecting the X-17 to the fader. 5. Replace the fader with a new one, and connect the multiway connector to the new fader. 6. Secure the new fader with the screws removed in the first step. 8 TASCAM X-17 Rear Panel / AC Adaptor in Use this jack to connect the PS-P17X AC adapter which comes with your X-17. Insert the plug following the arrow position of the AC adapter plug, and the white dot on the rear panel. WARNING DO NOT use any adapter with the X-17 except the PS-P17X adapter supplied with the X-17. Connect the AC adapter jack to the X-17 in the way shown on the illustration on the rear panel of the X-17. If you connect the AC adapter in any other way, you may damage the X-17. ! POWER switch @ BOOTH DIMMER switch When this switch is on, and when the MAIN MIC ON switch is pressed, the level of the signal from the BOOTH OUTPUT jacks is reduced by 20dB. # BOOTH OUTPUT These unbalanced RCA connectors output the preMASTER fader signal, whose level is adjusted using the BOOTH OUT control. Use the BOOTH DIMMER switch to reduce the level of this signal. $ AUX OUTPUT These unbalanced RCA connectors output the preMASTER fader signal, whose level is adjusted using the AUX OUT control. % MASTER OUTPUT (UNBAL) These unbalanced RCA connectors output the master output signals (post-MASTER fader). ^ SEND/RETURN Use these 1/4" TRS connectors (unbalanced) to insert an external effect in the MASTER OUTPUT signal path. This includes the four PGMs and the sampler. The connector is wired as follows. GND: Sleeve SEND: Tip RETURN: Ring & MASTER OUTPUT (BAL) These balanced XLR connectors output the master output signals (post-MASTER fader), wired as follows: GND: Pin 1 HOT: Pin 2 COLD: Pin 3