TEAC DM-3200 DM-3200 Automation Manual - Page 3

Table of Figures 1 - Introduction Figure 1.1: Timecode source selection (showing USB MTC selected 5 2 - Starting out with the timecode Figure 2.1: The automation FILES display 6 Figure 2.2: Automation SETUP screen 6 Figure 2.3: Naming a mix 7 3 - Automation overview Figure 3.1: Illustration of trim mode behavior 10 Figure 3.2: AUTO SETUP screen 11 Figure 3.3: AUTO FILES screen 13 Figure 3.4: AUTO CONFIG display 14 4 - Operation Figure 4.1: Writing a fader move over a previous static fader position with Auto Revert enabled 17 Figure 4.2: Writing a POD (or encoder) move over a previous static position with Auto Revert enabled 17 Figure 4.3: Writing a new fader move over a previous Dynamic fader move with Auto Revert enabled 18 Figure 4.4: Writing a new POD (or encoder) move over a previous Dynamic move with Auto Revert enabled 18 Figure 4.5: Writing a new fader move over a previous Static fader position with Auto Revert disabled 19 Figure 4.6: Writing a new POD or encoder move over a previous Static position with Auto Revert disabled . . . . 19 Figure 4.7: Writing a new fader move over previous Dynamic fader moves with Auto Revert disabled 20 Figure 4.8: Writing a new POD or encoder move over previous Dynamic moves with Auto Revert disabled . . . . . 20 Figure 4.9: Write to End over previous Static fader position 21 Figure 4.10: Write to End over previous Dynamic fader moves 21 Figure 4.11: Write to End over previous Static POD or encoder position 22 Figure 4.12: Write to End over previous Dynamic POD or encoder moves 22 Figure 4.13: Writing new switch events over previous switch events with Auto Revert enabled 24 Figure 4.14: Writing new switch events over previous switch events with Auto Revert disabled 25 Figure 4.15: Writing a new switch event with Write to End enabled 26 Figure 4.16: Trimming fader moves with Auto Revert enabled 28 Figure 4.17: Trimming POD and encoder moves with Auto Revert enabled 28 Figure 4.18: Trimming fader moves with Auto Revert disabled 29 Figure 4.19: Trimming POD and encoder moves with Auto Revert disabled 29 Figure 4.20: Trimming fader moves with Trim to End enabled 30 Figure 4.21: Trimming POD and encoder moves with Trim to End enabled 30 Figure 4.22: Initial status and dynamic data 32 Figure 4.23: Initial Status editing 33 TASCAM DM-3200 Automation Guide 3