TEAC PD-D2610mkII PD-D2610MKII Owner s Manual EFS - Page 3

ENGLISH Model for USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the equipment and/or the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Model for USA This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as class ! laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is as follows: This device complies with Part.15 of FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause interference 2) This device must accept any interference, including interference that may cause undesired operation of the device. Model for Canada Industry Canada's Compliance Statement: This Class B digital apparatus complies with Canadian ICES-003. V Precautions concerning batteries Misuse of batteries could cause them to rupture or leak leading to fire, injury or the staining of nearby things. Please read and observe the following precautions carefully. oo Be sure to insert the batteries with correct positive (¥) and negative (^) orientations. oo Use batteries of the same type. Never use different types of batteries together. CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Laser information This product contains a semiconductor laser system inside the cabinet and is classified as a "CLASS 1 LASER PRODUCT". To prevent being exposed to the laser beam, do not try to open the enclosure. Optical pickup: Type : EP-C101 Manufacturer : GUANGDONG EVER BRIGHT GROUP CO.,LTD Laser output : Less than 0.5mW on the objective lens Wavelength : 765 - 815 nm oo If the remote control is not used for a long time (more than a month), remove the batteries to prevent them from leaking. oo If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with new ones. oo Do not use batteries of types other than those specified. Do not mix new batteries with old ones or use different types of batteries together. oo Do not heat or disassemble batteries. Never throw batteries into fire or water. oo Do not carry or store batteries with other metallic objects. The batteries could short circuit, leak or explode. oo Never recharge a battery unless it is confirmed to be a rechargeable type. 3