TEAC SL-D800BT Owner's Mamual (English, Française) - Page 5

Wireless equipment precautions ENGLISH Compliance of radio transmitter and interference Model for USA This device complies with Part.15 of FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) This device must accept any interference, including interference that may cause undesired operation. Labeling of authorization FCC ID: TZI-SLD800BT Model for Canada Compliance of radio transmitter This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Labeling of authorization IC: 7234A-SLD800BT CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CAUTION Authorization of wireless devices are different in countries or regions. Please use only in the country where you purchased the product. oo Depending on the country, restrictions on the use of Bluetooth wireless technology might exist. Radiation Exposure requirements This equipment meets the regulation, which is recognized internationally, for the case of human exposure to radio waves generated by the transmitter. Statement of compliance Model for USA This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. Model for Canada The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Information for interference (FCC requirements) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. oo Reorient or relocate the equipment and/or the receiv- ing antenna. oo Increase the separation between the equipment and receiver. oo Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected. oo Consult the dealer or an experienced radio/TV techni- cian for help. Bluetooth® notes When using this unit with a mobile phone or other Bluetooth devices, they should be no more than about 10 m (33 ft) apart. Depending on the circumstances of use, however, the effective transmission distance might be shorter. Wireless communication with every device that supports Bluetooth wireless technology is not guaranteed. To determine the compatibility between this unit and another device that supports Bluetooth wireless technology, refer to that device's operation manual or contact the shop where you purchased it. 5