TEAC UD-505 Owners Manual English Francais Espanol - Page 16
Display, USB
View all TEAC UD-505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Display When on Z c UD-505 HEADPHONE AMPLIFIER After the above messages appear, the input source will be shown on the display. Playback source information The playback source information display will appear after turning the unit on as well as after about 7 seconds pass without operation when a setting screen is open. The input signal format or volume is shown to the right of the playback source. Press the DISPLAY button on the remote control to change what is shown. Display example Playback source information displayed Stopped Playback source USB check Shown when the connection is being checked Playing back Input signal format USB PCM 44.1k Sampling frequency Press the DISPLAY button on the remote control. Volume display Playback source name This shows the name of the selected source. The names on the display correspond to the selected connectors as follows. The names in parentheses appear when switching. USB (USB) USB port on the rear panel COAX1 (COAXIAL 1) RCA COAXIAL digital audio input connector on the rear panel COAX2 (COAXIAL 2) Coaxial connection with the digital audio input (OPT/COAX IN) on the front panel OPT1 (OPTICAL 1) OPTICAL digital audio input connector on the rear panel OPT2 (OPTICAL 2) Optical connection with the digital audio input (OPT/COAX IN) on the front panel Bluetooth (Bluetooth) Bluetooth device LINE (LINE IN) Analog audio input (LINE IN) connectors on the rear panel Input signal status This shows the input source signal status. Check The connection is being checked. PCM 32kHz PCM 44.1kHz PCM 48kHz PCM 88.2kHz PCM 96kHz PCM 128kHz PCM 176.4kHz PCM 192kHz PCM 256kHz PCM 352.8kHz PCM 384kHz PCM 705.6kHz PCM 768kHz DSD 2.8MHz DSD 5.6MHz DSD 11.2MHz DSD 22.5MHz These show the input signal type and sampling frequency. USB −45.5dB Volume 16