TP-Link 16dBi CPE520 V1.1 Installation Guide - Page 8

2. Connection and Installation Please connect and install the device as shown in the figure below. 5734 MADE IN CHINA IC:8853A-CPE510 FCC ID:TE7CPE510 This device complies with part 15 of the FCC Rules. Operation is subject to the followingtwo conditions:(1) This device may not cause harmful interference,and (2) this device must acceptany interference received, including interference that may cause undesired operation. IP: 192.168.0.254 Username: admin Password: admin Power: 24V 1A 5GHz 300Mbps 13dBi Outdoor CPE Default Settings: Model: CPE510 LAN0 PoE LAN Ethernet cable length up to 60m Slide to replace the cover of the CPE when all connections are nished. You should prepare an adequate Ethernet cable to connect the CPE and the passive PoE adapter. Shielded CAT5e (or above) cable with ground wire is recommended (refer to the next section). Connect to a computer, router or switch. (Depending on your intended usage and/or network topology.) At the selected site, approximately align the CPE to the direction that you have oriented. 05