TP-Link Archer C8 Archer C8 V 2 User Guide - Page 16
The Rear Panel, Archer C8, USB 2.0, RESET/WPS, WPS/Reset, Internet, Ethernet 1
View all TP-Link Archer C8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Archer C8 AC1750 Wireless Dual Band Gigabit Router Note: After a device is successfully added to the network by WPS function, the WPS LED will keep on for about 5 minutes and then turn off. 1.4.2 The Rear Panel Figure 1-1 Rear Panel sketch The following parts are located on the rear panel (View from left to right). USB 2.0: The USB 2.0 port connects to a USB 2.0 storage device or a USB 2.0 printer. RESET/WPS: Pressing this button for less than 5 seconds enables the WPS function. If your client devices, such as wireless adapters, that support Wi-Fi Protected Setup, then you can press this button to quickly establish a connection between the router and client devices and automatically configure wireless security for your wireless network. Pressing this button for more than 5 seconds enables the Reset function. With the router powered on, press and hold the WPS/Reset button for approximately 8 seconds. And then release the button and wait the router to reboot to its factory default settings. Internet: This port is where you will connect the DSL/cable Modem, or Ethernet. Ethernet (1, 2, 3, 4): These ports (1, 2, 3, 4) connect the router to the local PC(s). On/Off: The switch for the power. - 5 -