TP-Link EAP110 EAP110 V1 Quick Install Guide - Page 1
TP-Link EAP110 Manual
View all TP-Link EAP110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Quick Installation Guide EAP110 7106505541 REV1.0.0 2 Hardware Overview LED Indication Solid green The device is working properly. Flashing yellow Firmware update is in progress. Do not disconnect or power off the device. Flashing red System errors. RAM, Flash, Ethernet, WLAN or firmware may be malfunctioning. Double-flashing red, green, yellow The device is being reset to its factory default settings. 4 Power Supply The EAP110 can be powered with the provided PoE adapter. 3 PoE Adapter PoE LAN Switch 1 2 (Up to 100m) 1. Connect the ETHERNET port to the POE port of the PoE adapter using an Ethernet cable. The cable length can be up to 100 meters. 2. Connect the Ethernet cable from the switch to the LAN port of the PoE adapter. 3. Plug the female connector of the provided power cord into the PoE adapter, and the male connector to a power outlet. 1 Network Topology Requirement Internet EAP Controller Controller Host Router Switch A DHCP server (typically a router) is required to assign IP addresses to the EAP and clients in your local network. A computer running the EAP Controller software, which can be in the same or different subnet with the EAPs. Interface Panel RESET ETHERNET RESET With the device powered on, press and hold the button for about 8 seconds until the LED flashes red, then release the button. The device will restore to factory default settings. ETHERNET The port is to connect to the POE port of the provided PoE adapter for both data transmission and power supply through Ethernet cabling. Passive PoE Adapter Power LED PoE LAN Power LED The Power LED indicates the status of the electric current: green (0-0.8A), red (0.8A-1A). PoE Port This port is used to connect to the ETHERNET port of EAP110. LAN Port This Port is used to connect to your LAN. EAP EAP Clients EAP 3 Hardware Installation The EAP can be ceiling rail mounted, ceiling-mounted, and wall-mounted. The instructions for various mounting options are on the back of this Quick Installation Guide. Option 1: Ceiling Rail Mounting Option 2: Ceiling Mounting Option 3: Wall Mounting 5 Software Configuration To quickly set up a wireless network connection with mass EAPs, please follow the steps below. Note: The IP address of the management computer must be reachable for the EAPs in the network. Step 1: Installing the EAP Controller Find the EAP Controller application file on the Resource CD (for Windows user only) or from our website at www.tp-link.com. Run the file and follow the wizard to install the EAP Controller on the computer. Step 2: Configuring the EAP Controller Launch the EAP Controller and follow the configuration wizard to create a primary wireless network. After the wizard is finished, a login screen will appear. Enter the admin name and password you created and click Sign In. Step 3: Adopting the EAP devices Adopt the EAP devices in the Controller management interface to change the status from pending to connected. For More Configurations Now you can manage your wireless network and view network statistic using the EAP Controller. Please refer to the EAP Controller User Guide to learn more information on configuring and using the Controller software.