TP-Link RE200 RE200(EU) V1 QIG - Page 1

Quick Installation Guide Applicable Model: RE200 WPS Method ONE: Quick Setup using the WPS Button Method TWO: Setup using your Web Browser LED Explanation 5G/2.4G Solid Green: The Range Extender is connected to the 5G/2.4G wireless network of your main Router/AP, and the signal strength is strong. Solid Red: The Range Extender is connected to the 5G/2.4G wireless network of your main Router/AP, but the signal strength is weak. Off: The Range Extender isn't connected to your main Router/AP. (Wireless Signal) On: The Range Extender's wireless function is enabled. Off: The Range Extender's wireless function is disabled. (ETHERNET) On: A device is connected to the ETHERNET port, but there is no activity. Flashing: A device is connected to the ETHERNET port, and is active. Off: No device is connected to the ETHERNET port. (Power) On: The Range Extender is on. Off: The Range Extender is off. (RE) On: The Range Extender has established a secure connection. Flashing: The Range Extender is establishing a secure connection. Off: No active connection. 7106504739 REV1.0.0 Method ONE Quick Setup using the WPS Button Use this if your Router or Access Point(AP) supports WPS 1 Power on Plug your Range Extender into a power outlet near your Router/AP. 2 Push the two WPS buttons 1 Push the WPS button on your Router/AP. 2 Immediately push the button on your Range Extender. Wait until the ' ' and ' ' LEDs light up. If the WPS connection fails, please go to Method TWO. The ' ' LED should go from flashing to solid, showing that WPS connection has succeeded, then it will turn off in 2 minutes. 3 Relocate After you have configured your Range Extender, move it to a location for the best signal quality and coverage in your house. The Range Extender will automatically reconnect to your main RouterAP within about 30 seconds after you plug it into another power outlet. * Keep the following in mind: far away The ideal location for your Range Extender is Halfway between your main Router/AP and Wi-Fi-enabled devices. If possible, try to place your Range Extender in a location where the 2.4G/5G LEDs are Green. Keep the Range Extender away from devices like cordless phones, Bluetooth devices and Microwave Ovens to minimize wireless interference. If possible, try to place your extender in open corridors or spacious locations rather than a crowded room. Enjoy! The Range Extender shares the same Wi-Fi Network Name (SSID) and Wi-Fi Password with your main Router/AP. SSID (TP-LINK_XXGHz_XXX) Password (ABCDEF) SSID (TP-LINK_XXGHz_XXX) Password (ABCDEF) Frequently Asked Questions (FAQ) Q1. How to reset the Range Extender? A1: While the Range Extender is plugged into a power outlet, press the RESET button with a pen for 1 second. Wait 2 seconds until all the LEDs flash once. OR A2: Use your web browser to log into the management page, go to "System Tools -> Factory Defaults" and click "Restore". Wait 5 seconds until all the LEDs flash once. RESET RESET ETHERNET Q2. I typed http://tplinkextender.net in the browser URL bar, why can't I see the quick setup page? A: First, make sure your computer is connected to the extender network and disconnected from any other network. Second, make sure your computer is set to "Obtain an IP address automatically". Q3. What's the technical support hotline? A: Please visit "www.tp-link.com", find "Support>Contact Technical Support>Hotline Support" for more information.