TP-Link T1600G-18TSTL-SG2216 T1600G-18TSUN V1 Configuration Guide - Page 573

Configuring Network Security IP-MAC Binding Configurations Step 2 Step 3 Step 4 Step 5 ip source binding hostname ip-addr mac-addr vlan vlan-id interface gigabitEthernet port { none | arp-detection } [ forced-source {arp-scanning | dhcp-snooping} ] Manually bind the host name, IP address, MAC address, VLAN ID and port number of the host, and configure the protect type for the host. In addition, you can change the source of the entry as ARP Scanning or DHCP Snooping. hostname: Specify a name for the host. It contains 20 characters at most. ip-addr: Enter the IP address of the host. mac-addr: Enter the MAC address of the host, in the format of xx:xx:xx:xx:xx:xx. vlan-id: Enter the VLAN ID of the host. port: Enter the number of the port on which the host is connected. none | arp-detection : Specify the protect type for the entry. None indicates this entry will not be applied to ARP Detection; arp-detection indicates this entry will be applied to ARP Detection. arp-scanning | dhcp-snooping: Change the source of the entry to ARP Scanning or DHCP Snooping. show ip source binding Verify the binding entry. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to bind an entry with the hostname host1, IP address 192.168.0.55, MAC address AA-BB-CC-DD-EE-FF, VLAN ID 10, port number 1/0/5, and enable this entry for the ARP detection feature. Switch#configure Switch(config)#ip source binding host1 192.168.0.55 aa:bb:cc:dd:ee:ff vlan 10 interface gigabitEthernet 1/0/5 arp-detection Switch(config)#show ip source binding U No. Host IP-Addr MAC-Addr VID Port ACL Col. -- --- -------- ----- 1 1 host1 192.168.0.55 aa:bb:cc:dd:ee:ff 10 Gi1/0/5 ARP-D Switch(config)#end Switch#copy running-config startup-config Configuration Guide 550