TP-Link T2600G-52TS T2600G Series Switches CLI Reference Guide Guide - Page 24

Preface This Guide is intended for network administrator to provide referenced information about CLI (Command Line Interface). The device mentioned in this Guide stands for T2600G-18TS/T2600G-28TS/T2600G-28TS-DC/T2600G-28MPS/T2600G-28SQ/ T2600G-52TS JetStream Gigabit L2 Managed Switch without any explanation. The commands in this guide apply to these models if not specially noted, and T2600G-28TS is taken as an example model in the example commands. Some models featured in this guide may be unavailable in your country or region. For local sales information, visit https://www.tp-link.com. Overview of this Guide Chapter 1: Using the CLI Provide information about how to use the CLI, CLI Command Modes, Security Levels and some Conventions. Chapter 2: Line Commands Provide information about the commands used to make related configurations for the desired users and set the priority of the console media type. Chapter 3: User Interface Provide information about the commands used to switch between five CLI Command Modes. Chapter 4: User Management Commands Provide information about the commands used for user management. Chapter 5: System Configuration Commands Provide information about the commands used for configuring the System information and System IP, reboot and reset the switch, upgrade the switch system and commands used for cable test. Chapter 6: EEE Configuration Commands Provide information about the commands used for configuring EEE. Chapter 7: SDM Template Commands Provide information about the commands used for configuring the SDM templates. Chapter 8: Time Range Commands Provide information about the commands used for configuring the time range. Chapter 9: Port Configuration Commands Provide information about the commands used for configuring the Speed, Negotiation Mode, and Flow Control for Ethernet ports. Chapter 10: Port Isolation Commands Provide information about the commands used for configuring Port Isolation function. 1