TP-Link TD-W8901G Quick Installation Guide - Page 2
Solid light, Solid light or flashing, Solid light if the corresponding, port is connected - configure
UPC - 845973060046
View all TP-Link TD-W8901G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Plug the provided Power Adapter into the Power jack on the back of the Router and the other end to a standard electrical wall socket. Power on all your network devices and then check to see if the LEDs of the Router display normally as the diagram below describes. Solid light Solid light or flashing Solid light or flashing Solid light if the corresponding port is connected Note If the LEDs display abnormally, please check to see if all the cable connectors (power adapter, phone line and Ethernet cable) are well connected to your device. With the phone line well connected, if the ADSL LED turns off after flashing, please contact your ISP to ensure that your internet connection is active. Note To configure the device, you can either run the setup CD-ROM (method one), or run the Web based Quick Setup Wizard (method two). TP-LINK strongly recommends that you run the setup CD-ROM. 2