TP-Link TF-3239D User Guide - Page 1

Ø Supports ACPI, PCI power management Ø Complies with the IEEE802.3u Fast Ethernet, 100Base-TX standard and IEEE802.3 CSMA/CD 10Base-T standard Ø Supports Full Duplex Flow Control (IEEE 802.3x) Ø Full duplex design to double the performance Ø Supports Auto-Negotiation function Ø Auto-setups IRQ and I/O address Ø Contains two large (2Kbyte) independent receive and transmit FIFOs Ø One STP/UTP connector for 10Mbps or 100Mbps network Speed Ø Provides diagnostic software and one LED to indicate network Link/activity Ø Supports smart remote boot ROM and provides the help for RPL/PXE(Exclude TF-3239DL) Ø Supports ODI Driver for NetWare 3.x, 4.x, NDIS Driver for LAN Manager, Windows 95, Windows NT, Windows 2000, Packet driver forTCP/IP Chapter 2 Installation Card Installation To insert The Product into your computer, follow the steps list below. 1 Turn off the computer and remove its cover. 2 Insert The Product into a PCI slot. 3 Secure the Product to the rear of the computer chassis and put back the computer cover. 4 Connect the Product to the network using twisted-pair cables. Driver Installation 3 Use the drivers supplied by the diskette included in The Product. For detail description, please refer to "help" in the diskette provided by the Product. Appendix A: Troubleshooting If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub complies with the adapter specification, such as 10Mbps 10Base-T or 100Mbps 100Base-TX. Then recheck the LED. The Product provided one LEDs to indicate network status. LINK/ACTIVE LED A red LED indicates if the 10 or 100Mbps STP/UTP has been link OK or not and is working or not. When the light is OFF, it indicates that the STP/UTP port has not been connected or link not OK; When the light is ON, it indicates that the STP/UTP port link OK. When the light is BLINKING, it indicates that the STP/UTP port is receiving data or transmitting data. Appendix B: Technical Specification Topology: Star Connector Supported: RJ45 Standard: IEEE802.3 10Base-T IEEE802.3u 100Base-TX Transmission Rate: 100Mbps or 200Mbps Hardware: IBM PC compatibles(It must have PCI slot) IRQ Line: Assigned by system 4 71030429 I/O Address: Assigned by system Software: ODI driver for NetWare 3.x, 4.x, NDIS driver for Microsoft LAN manager and Windows 98, Windows ME, Windows NT, Windows 2000 Packet driver for TCP/IP Temperature: 0o C to 40o C (Operating) Humidity: 5% to 95% (Non-condensing) Power consumption: 1W(Max) Appendix C: Contact Information For help with the installation or operation of the TP-LINK TF-3239D/ TF-3239DL Adapter, please contact us. TP-LINK TECHNOLOGIES CO., LTD. Add: Fl.3, Bldg.R1-B, High-Tech Industrial Park, Shennan Road, Shenzhen, China E-mail: [email protected] Website: http://www.tp-link.com User's Guide TF-3239D/TF-3239DL 10/100M Fast Ethernet Adapter Ver: 2.0 Made in China 5 2