TP-Link TL-PA201 STARTER KIT User Guide - Page 8
Physical Interface - 200mbps powerline ethernet
View all TP-Link TL-PA201 STARTER KIT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
TL-PA201 200Mbps Powerline Ethernet Adapter ) Note: 1. When PLC is flashing, different colours represent different data transmitting performance. Green LED:Power Line speed>80 Mbps Amber LED:Power Line speed30Mbps Red LED:Power Line speed
TL-PA201
200Mbps Powerline Ethernet Adapter
3
)
Note:
1.
When PLC is flashing, different colours represent different data transmitting performance.
Green LED
:
Power Line speed>80 Mbps
Amber LED
:
Power Line speed<80 Mbps and >30Mbps
Red LED
:
Power Line speed<30 Mbps
2.
5 minutes later since the device connected to the Homeplug is powered off, the Homeplug will
switch to Power-saving Mode automatically.
2.3 Physical Interface
There are four physical interfaces on this Powerline Ethernet Adapter.
Interface
Description
Ethernet
One 10/100Mbps Ethernet port connected to PC LAN card or broadband
device
Power Plug
Power Plug connected to any 100V ~ 240V AC power socket
Reset
Use a pin to press and hold this Reset button for 3 to 10 seconds then the
device will restore to factory defaults
Pair
Press and hold the Pair button for about 3 to 8 seconds, then release it. The
Power LED will begin flashing. Perform the same step to the Rest of the
Homeplug devices in 2 minutes
)
Note:
1.
If you press the Pair button for more than 10 seconds, The PLC will leave the network it is
associated with and its network name assumes a random value. The Power LED turns off when it
disconnects from the Powerline network.
2.
For detail information about the Reset button and Pair button, please refer to
Charpter 5 Advanced
Feature:How to Use the Push buttons