Home » TP-Link Manuals » Hubs & Switches » TP-Link TL-SL2210 » Manual Viewer

TP-Link TL-SL2210 TL-SL2210 V1 CLI Reference Guide 1910010922 - Page 85

storm-control multicast, storm-control unicast

Add to My Manuals
Save this manual to your list of manuals

Page 85 highlights

Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet / interface gigabitEthernet / interface range gigabitEthernet) Example Enable the broadcast control function for port 5: TL-SL2428(config)# interface fastEthernet 1/0/5 TL-SL2428(config-if)# storm-control broadcast storm-control multicast Description The storm-control multicast command is used to enable the multicast control function. To disable the multicast control function, please use no storm-control multicast command. Multicast control function allows the switch to filter multicast in the network. If the transmission rate of the multicast packets exceeds the set bandwidth, the packets will be automatically discarded to avoid network broadcast storm. Syntax storm-control multicast [rate rate] no storm-control multicast Parameter rate -- Select the bandwidth for receiving multicast packets on the port. The packet traffic exceeding the bandwidth will be discarded. By default, the value is "128K". Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet / interface gigabitEthernet / interface range gigabitEthernet) Example Enable the multicast control function for port 5: TL-SL2428(config)# interface fastEthernet 1/0/5 TL-SL2428(config-if)# storm-control multicast storm-control unicast Description 75

Section	Page
Preface	11
Chapter 1 Using the CLI	13
1.1 Accessing the CLI	13
1.2 CLI Command Modes	14
1.3 Security Levels	17
1.4 Conventions	17
1.4.1 Format Conventions	17
1.4.2 Special Characters	18
1.4.3 Parameter Format	18
Chapter 2 User Interface	19
enable	19
enable password	19
disable	20
configure	20
exit	20
end	21
Chapter 3 IEEE 802.1Q VLAN Commands	22
vlan	22
interface vlan	22
name	23
switchport general allowed vlan	23
switchport pvid	24
show vlan summary	24
show vlan brief	25
show vlan	25
show interface switchport	26
Chapter 4 Voice VLAN Commands	27
voice vlan	27
voice vlan aging time	27
voice vlan priority	28
voice vlan mac-address	28
switchport voice vlan mode	29
switchport voice vlan security	30
show voice vlan	30
show voice vlan oui	31
show voice vlan switchport	31
Chapter 5 Etherchannel Commands	33
channel-group	33
port-channel load-balance	34
lacp system-priority	34
lacp port-priority	35
show etherchannel	35
show etherchannel load-balance	36
show lacp	36
show lacp sys-id	37
Chapter 6 User Manage Commands	38
user name	38
user access-control ip-based	39
user access-control mac-based	39
user access-control port-based	40
user max-number	41
user idle-timeout	41
show user account-list	42
show user configuration	42
Chapter 7 System Log Commands	44
logging buffer	44
logging file flash	45
clear logging	45
logging host index	46
show logging local-config	47
show logging loghost	47
show logging buffer	47
show logging flash	48
Chapter 8 SSH Commands	49
ip ssh server	49
ip ssh version	49
ip ssh timeout	50
ip ssh max-client	50
ip ssh download	51
show ip ssh	51
Chapter 9 SSL Commands	53
ip http secure-server	53
ip http secure-server download certificate	53
ip http secure-server download key	54
show ip http secure-server	55
Chapter 10 MAC Address Commands	56
mac address-table static	56
mac address-table aging-time	57
mac address-table filtering	57
mac address-table max-mac-count	58
show mac address-table address	59
show mac address-table aging-time	59
show mac address-table max-mac-count interface	60
show mac address-table interface	60
show mac address-table mac-num	61
show mac address-table mac	61
show mac address-table vlan	62
Chapter 11 System Commands	63
system-time manual	63
system-time ntp	63
system-time dst predefined	65
system-time dst date	66
system-time dst recurring	67
hostname	68
location	68
contact-info	69
ip management-vlan	69
ip address	70
ip address-alloc dhcp	70
ip address-alloc bootp	71
reset	71
reboot	72
copy running-config startup-config	72
copy startup-config tftp	72
copy tftp startup-config	73
firmware upgrade	73
ping	74
tracert	75
loopback interface	75
show system-info	76
show system-time	76
show system-time dst	77
show system-time ntp	77
show cable-diagnostics interface	77
Chapter 12 Ethernet Configuration Commands	79
interface fastEthernet	79
interface range fastEthernet	79
interface gigabitEthernet	80
interface range gigabitEthernet	80
description	81
shutdown	81
flow-control	82
media-type	82
duplex	83
speed	84
storm-control broadcast	84
storm-control multicast	85
storm-control unicast	85
bandwidth	86
clear counters	87
show interface status	87
show interface counters	88
show interface description	88
show interface flowcontrol	89
show interface configuration	89
show storm-control	90
show bandwidth	90
Chapter 13 QoS Commands	92
qos	92
qos cos	92
qos dscp	93
qos queue cos-map	94
qos queue dscp-map	94
qos queue mode	95
show qos interface	96
show qos cos-map	97
show qos dscp-map	97
show qos queue mode	98
show qos status	98
Chapter 14 Port Mirror Commands	99
monitor session destination interface	99
monitor session source interface	100
show monitor session	101
Chapter 15 Port Isolation Commands	102
port isolation	102
show port isolation interface	102
Chapter 16 Loopback Detection Commands	104
loopback-detection(global)	104
loopback-detection interval	104
loopback-detection recovery-time	105
loopback-detection(interface)	105
loopback-detection config	106
loopback-detection recover	106
show loopback-detection global	107
show loopback-detection interface	107
Chapter 17 ACL Commands	109
access-list create	109
mac access-list	109
access-list standard	110
access-list extended	111
rule	112
access-list policy name	112
access-list policy action	113
access-list bind(interface)	114
access-list bind(vlan)	114
show access-list	115
show access-list policy	115
show access-list bind	115
Chapter 18 DHCP Filtering Commands	117
ip dhcp filtering	117
ip dhcp filtering trust	117
show ip dhcp filtering	118
show ip dhcp filtering interface	118
Chapter 19 MSTP Commands	119
spanning-tree(global)	119
spanning-tree(interface)	119
spanning-tree common-config	120
spanning-tree mode	121
spanning-tree mst configuration	121
instance	122
name	123
revision	123
spanning-tree mst instance	124
spanning-tree mst	124
spanning-tree priority	125
spanning-tree tc-defend	126
spanning-tree timer	126
spanning-tree hold-count	127
spanning-tree max-hops	128
spanning-tree bpdufilter	128
spanning-tree bpduguard	129
spanning-tree guard loop	129
spanning-tree guard root	130
spanning-tree guard tc	130
spanning-tree mcheck	131
show spanning-tree active	131
show spanning-tree bridge	132
show spanning-tree interface	132
show spanning-tree interface-security	133
show spanning-tree mst	134
Chapter 20 IGMP Commands	135
ip igmp snooping(global)	135
ip igmp snooping(interface)	135
ip igmp snooping immediate-leave	136
ip igmp snooping drop-unknown	136
ip igmp snooping vlan-config	137
ip igmp snooping multi-vlan-config	138
ip igmp snooping filter add-id	139
ip igmp snooping filter(global)	140
ip igmp snooping filter(interface)	140
ip igmp snooping filter maxgroup	141
ip igmp snooping filter mode	141
show ip igmp snooping	142
show ip igmp snooping interface	142
show ip igmp snooping vlan	143
show ip igmp snooping multi-vlan	144
show ip igmp snooping groups	144
show ip igmp snooping filter	145
Chapter 21 SNMP Commands	146
snmp-server	146
snmp-server view	146
snmp-server group	147
snmp-server user	148
snmp-server community	150
snmp-server host	150
snmp-server engineID	152
snmp-server traps snmp	152
snmp-server traps link-status	153
snmp-server traps	154
snmp-server traps mac	155
snmp-server traps vlan	155
rmon history	156
rmon event	157
rmon alarm	158
show snmp-server	159
show snmp-server view	160
show snmp-server group	160
show snmp-server user	160
show snmp-server community	161
show snmp-server host	161
show snmp-server engineID	161
show rmon history	162
show rmon event	162