TP-Link TL-WA855RE TL-WA855REEU V1 Quick Install Guide - Page 1

Quick Installation Guide 7106505757 REV1.0.1 Applicable Model: TL-WA855RE For more information, please visit our website: http://www.tp-link.com Option ONE Quick Setup using the WPS Button Your router should support WPS. Otherwise, please use Option TWO. Power on Plug in next to your router. Connect 1 Press the WPS button on your router. 2 Press the button, the LED starts blinking. Wait about 30 seconds until the LED changes to solid red. The LED should turn solid green (or orange), indicating successful connection. If not, please use Option TWO. Relocate 1 Plug in the extender halfway between your router and the Wi-Fi dead zone. 2 Wait about 1 minute until the LED is lit with a solid green. If not, relocate it closer to the router to achieve a good (or better) signal quality. Host Network Extended Network Green: Good location Orange: Too far away Enjoy! The extended network shares the same network name and password as your host network. SSID TP-LINK_abc Password: 12345678 SSID: TP-LINK_abc Password: 12345678 LED Explanation Status Color Green (On) Orange Red (Blinking) (Off) Green -- Indication The extender is connected to the router, and is in a good location. The extender is connected to the router, but is too far away from the router. No active connection. WPS connection is in progress, or the extender is initializing. The extender is off. Q1. What should I do if my router doesn't have a WPS button? A: Please use Option TWO to set up the extender. Q2. Why can't I see the login page after entering http://tplinkrepeater.net in the browser? A1: Make sure your computer is connected to extender's network. A2: Make sure your computer is set to obtain an IP address automatically. Q3. Why the LED doesn't turn solid green (or orange) after I completed Option TWO? A1: You may have entered the incorrect Wi-Fi password of your host network during the configuration. Please log into the extender's web-based interface to check the password and try again. A2: Reset the extender and go through the configuration again. Q4. How do I reset the extender? A: While the extender is powered on, use a pin to press the RESET button, the LED should turn off momentarily, then release the button. ©2015 TP-LINK