TP-Link TL-WPA7510 KIT TL-WPA7510 KITEU V1 Quick Installation Guide - Page 1

TL-WPA7510 KIT Hello, I'm here. Follow me to extend your Wi-Fi network. Powerline 1000Mbps Extender TL-WPA7510 1000Mbps Adapter TL-PA7010 (For demonstration only) 2 Plug the two powerline devices into power outlets on the same electrical circuit. Note: It is recommended to plug in these powerline devices next to each other and then relocate the extender to the desired location at step 4. Router LAN 1 WAN Ethernet Cable 3 Pair the powerline devices. A Press the Pair button on the adapter for 1 second. The Power LED starts blinking. Note: If the Power LED does not blink, press the Pair button again. B Within 2 minutes, press the Pair button on the extender for 1 second. The Power LED starts blinking. C When the Powerline LED on the extender turns solid, the pairing process is complete. Pair Blinking 1000Mbps Adapter TL-PA7010 within 2 minutes 4 Relocate the extender to the Wi-Fi "dead" zone. Use the SSID (network name) and password on the provided Wi-Fi Info Card to connect to the internet. Note: A red Powerline LED indicates poor signal strength. Move the extender to another location. Wi-Fi LED Pair Reset Blinking On 1000Mbps Extender TL-WPA7510