TRENDnet TE100-PCIW Manual - Page 2
TE100-PCIW, 100Base-TX, PCI Bus, Ethernet Adapter - windows 98 driver
View all TRENDnet TE100-PCIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Product Specifications Standard IEEE802.3/802.3u 10Base- T/100Base-TX standards Bus Interface 32-bit bus master Hardware Interrupts PCI INTA Base I/O Address Assigned by BIOS Cable Connections RJ-45(10Base-T) UTP Category 3,4,5 or better. RJ-45(100Base-TX) UTP Category 5 or better Software Compatibility Microsoft Windows NT, Windows 95/98, LAN Manager, Novell Netware, Windows for Workgroups, IBM LAN Server, IBM LAN Support, NDIS Driver, DEC PATHWORKS, Banyan, IBM TCP/IP for DOS & OS/2, SCO UNIX, Packet Driver, FTP PC/TCP, NCSA TCP/IP LED Indications LINK - Green ACT - Green 100 - Green FDX - Green Input Power Requirements 100 - 240 VAC, 50 -60Hz Power Consumption 4.2W Operational States (Full load) 3.9W Static State Dimensions Certification Copyright Notice 130 x 70 mm FCC Class A, CE Mark Contents are subject to revision without prior notice. All rights reserved. Trademarks All other trademarks belong to their respective owners. FCC Compliance Statement Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in residential installation . This equipment generated, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications. However, these are no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio TV technician for assistance. NOTICE: I. The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. II. Shielded interface cables and AC power cord, must be used in order to comply with emission limits. CE Mark Declaration of Conformance This is to certify that this product complies with ISO/IEC Guide 22 and EN45014. It conforms to the following specifications: EMC EN55022(1988)/CISPR22(1985) EN60555-2(1987) prEN55024-2(1990)/IE801-2(1991) prEN55024-3(1991)/IE801-3(1984) PrEN55024-4(1992)/IE801-4(1988) Class A Class A 4KV CD, 8KV AD 3V V/m 1KV - (power line) 0.5KV - (signal line) This product complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC. TE100-PCIW 10/100Base-TX PCI Bus Ethernet Adapter Quick Installation Guide TRENDware International, Inc. 2421 W. 205th St., Ste. D-102 Torrance, CA 90501 Tel: 310-328-7795 Fax: 310-328-7798 www.trendware.com P/N : 7743902009