TRENDnet TEW-210APB User's Guide - Page 4

Installation - wireless access point

Get TRENDnet TEW-210APB PDF manuals and user guides View all TRENDnet TEW-210APB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

3. Installation 1. Mount the Access Point firmly to the wall or proper location that is determined during the site survey. 2. Make sure the antennas are in a vertical position (if not, rotate over 90 degrees). 3. Insert the power connector. 4. Attach the UTP Ethernet cable to the Access Point. At the front of the Access Point you will see three LEDs. If all goes well, the middle LED (power) and the lowermost LED(LINK) will fire and uppermost LED(ACT) will flash whenever there is traffic on the respective networks which is at least ten times per second for the wireless LAN because of so-called 'beacons'. You can reset the Access Point's settings to factory defaults by pushing a paperclip in the little hole next to the power connector. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
3. Installation
1. Mount the Access Point firmly to the wall or proper location that is
determined during the site survey.
2. Make sure the antennas are in a vertical position (if not, rotate over 90
degrees).
3. Insert the power connector.
4. Attach the UTP Ethernet cable to the Access Point.
At the front of the Access Point you will see three LEDs.
If all goes well, the middle LED (power) and the lowermost LED(LINK) will fire
and uppermost LED(ACT) will flash whenever there is traffic on the respective
networks which is at least ten times per second for the wireless LAN because
of so-called ‘beacons’.
You can reset the Access Point’s settings to factory defaults by pushing a
paperclip in the little hole next to the power connector.
4