TRENDnet TEW-211BRP Manual - Page 5

Hardware Installation Front Panel The front panel provides LED's for device status. Refer to the following table for the meaning of each feature. PWR Power status of the TEW-211BRP WirelessAP Router. A steady LED indicates the power is applied to the unit. WLAN The WLAN LED will be ON when AP function enable, at this time Wireless clients are able to connect to the AP. WAN Wide Area Network status. WAN LED is illuminated when there is a good connection to the 10 BaseT mode Ethernet port. MODEM Indicates console port Carrier Detect status. When modem connection is established then LED should be steady on. STAT System status indicator. A flickering light indicates that when data is reading from or writing into flash. Rear Panel The rear panel features 4 LAN ports, WAN port, Modem port and Factory Reset button. Refer to the following table for the meaning of each feature. Power (DC 5v) Used to connect to the power outlet. Only use the power adapter provided with the Wireless AP router. Use of an unauthorized power adapter may cause damage to your device and violate your warranty. Modem Port used to connect an external analog backup modem/ISDN TA. WAN The RJ-45 Ethernet port labeled WAN is used to connect your Wireless AP Router to your xDSL or Cable modem. Reset LAN Resets the configuration to default settings. The RJ-45 Ethernet ports used to connect your PC or (1,2,3,4) HUB, The Ethernet Cable used can be normal Ethernet cables or even Crossover Cable. The TEW-211BRP has internal AutoCrossover detection circuit to automatic identify them. 4