TRENDnet TEW-410APBplus User's Guide - Page 6
Hardware Installation - reset
View all TRENDnet TEW-410APBplus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
TEW-410APBplus 3. Hardware Installation Front Panel The front panel provides LED's for device status. Refer to the following table for the meaning of each feature. LED STATUS Description PWR/STAT Off No power Green On 1. Power minute) on 2. Reset to default 3. Firmware upgrade (first 1 Green Blink 1. System up 2. Power on 3. Firmware upgrade Link Off no Ethernet link detected Green On 10/100Mbps Fast Ethernet link detected. No activity. Green Blink Indicates data traffic on the 10/100 Mbps LAN Active Green Indicates the device is linking or active data through wireless Blink links Rear Panel The rear panel features 1 LAN ports and Reset button. Refer to the following table for the meaning of each feature. Used to connect to the power outlet. Only use the power Power (DC 5v) adapter provided with the device. Use of an unauthorized power adapter may cause damage to your device and violate your warranty. Reset Press the Reset Button for approximately ten seconds, all configurations will set to factory default settings. LAN The RJ-45 Ethernet ports used to connect your PC, hub, switch or Ethernet network. AP Default Settings The default settings are shown following. User admin Password admin AP IP Address 192.168.1.250 AP Subnet Mask 255.255.255.0 RF ESSID ap11g 11g RF Channel 6 Mode 11b+g Encryption Disabled User's Guide 5