TRENDnet TEW-435BRM Quick Installation Guide - Page 9

Troubleshooting - reset

Page 9 highlights

Troubleshooting Q1: I typed http://192.168.0.1 in my Internet Browser's Address Bar, but an error message says "The page cannot be displayed." How can I get into the TEW-435BRM's web configuration page? A1: First, check your hardware settings again by following the instructions in Section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure your TCP/IP settings are set to Obtain an IP address automatically (see the steps below). 1. Go into the Control Panel and doubleclick the Network Connections icon, right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol (TCP/IP) and then click Properties. Then click on Obtain an IP address automatically. Fourth, press on the factory reset button for 15 seconds. Q2: The Modem does not auto-detect my DSL connection. What should I do? A2: First, verify that your DSL account is activated. Second, make sure all the cables are properly connected (see Section 2). Third, in Section 3, select manual selection in the Setup Wizard and configure the Modem based on information provided by your ISP. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11

7
Troubleshooting
Q1:
A1:
I typed http://192.168.0.1 in my Internet Browser's Address Bar, but an error
message says “The page cannot be displayed.” How can I get into the
TEW-435BRM's web configuration page?
First, check your hardware settings again by following the instructions in
Section 2.
Second, make sure the LAN and WLAN lights are lit.
Third, make sure
your TCP/IP settings are set to
Obtain an IP address automatically
(see the
steps below).
1.
Go into the
Control Panel
and double-
click the
Network Connections
icon,
right-click the
Local Area Connection
icon and then click
Properties
.
2.
Click
Internet Protocol (TCP/IP)
and
then click
Properties
.
Then click on
Obtain an IP address automatically.
Fourth, press on the factory reset button for 15 seconds.
The Modem does not auto-detect my DSL connection.
What should I do?
First, verify that your DSL account is activated.
Second, make sure all the
cables are properly connected (see Section 2).
Third, in Section 3, select manual
selection in the Setup Wizard and configure the Modem based on information
provided by your ISP.
Q2:
A2: