TRENDnet TEW-730APO User's Guide - Page 36

TRENDnet User's Guide Access Control Mode TEW-730APO  LAN: Select when your access controller is connected on your LAN (Local Are Network).  Internet: Select this option to have your access controller access the access point via Internet and enter the elect the mode you would want the access point to operate on. o Management Port: Enter the port to assign to access the access point via Internet o FW Upgrade Port: Enter the port to use when performing upgrade through the Internet. VLAN  Enable 802.1 Q VLAN: Select this option to enable VLAN  Management VLAN ID: Enter the VLAN ID to assign the access point. Information This page displays thin access points configured information. 1. Log into the management page (see "Access the management page" on page 9). 2. Click on Thin AP and Basic Settings.  Firmware version: Current firmware version of the access point  MAC Address: Displays the MAC address of the access point  System Uptime: Displays the duration of the access point being active  Registered Status: Displays the registration status of the access point with an access controller  AC MAC Address: Displays the MAC address of the access controller assigned to the access point. Virtual AC In this mode the access point becomes the virtual access controller that can control thin access points on the network. Configuration 1. Log into the management page (see "Access the management page" on page 9). 2. Your access point will prompt you for a user name and password. 3. Enter the default user name and password and then click Login. Default User Name: admin Default Password: admin 4. Click the System button on the left side and then System Settings. © Copyright 2015 TRENDnet. All Rights Reserved. 35