TRENDnet TEW-755AP2KAC Users Guide - Page 44
Troubleshooting, Windows 7/8.1/10, Windows Vista, Windows XP/2000
View all TRENDnet TEW-755AP2KAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
TRENDnet User's Guide Troubleshooting Q: I typed http://192.168.10.200 in my Internet Browser Address Bar, but an error message says "The page cannot be displayed." How can I access the controller management page? Answer: 1. Check your hardware settings again. See "Access point Installation" on page 8. 2. Make sure the Power and port Link/Activity and WLAN lights are lit. 3. Make sure your network adapter TCP/IP settings are set to Use the following IP address or Static IP(see the steps below). 4. Make sure your computer is connected to one of the Ethernet controller ports. 5. Since the controller default IP address is 192.168.10.200, make sure there are no other network devices assigned an IP address of 192.168.10.200 Windows 7/8.1/10 a. Go into the Control Panel, click Network and Sharing Center. b. Click Change Adapter Settings, right-click the Local Area Connection icon. c. Then click Properties and click Internet Protocol Version 4 (TCP/IPv4). d. Then click Use the following IP address, and make sure to assign your network adapter an IP address in the subnet of 192.168.10.x. Click OK Windows Vista a. Go into the Control Panel, click Network and Internet. b. Click Manage Network Connections, right-click the Local Area Connection icon and click Properties. c. Click Internet Protocol Version (TCP/IPv4) and then click Properties. d. Then click Use the following IP address, and make sure to assign your network adapter an IP address in the subnet of 192.168.10.x. Click OK Windows XP/2000 a. Go into the Control Panel, double-click the Network Connections icon b. Right-click the Local Area Connection icon and the click Properties. c. Click Internet Protocol (TCP/IP) and click Properties. d. Then click Use the following IP address, and make sure to assign your network adapter an IP address in the subnet of 192.168.10.x. Click OK Note: If you are experiencing difficulties, please contact your computer or operating system manufacturer for assistance. © Copyright 2017 TRENDnet. All Rights Reserved. TEW-755AP2KAC / TEW-821DAP2KAC Q: If my controller IP address is different than my network's subnet, what should I do? Answer: You should still configure the controller first. After all the settings are applied, go to the controller configuration page, click on System, click IPv4 Setup and change the IP address of the controller to be within your network's IP subnet. Click Apply, then click OK. Then click Save Settings to Flash (menu) and click Save Settings to Flash to save the IP settings to the NV-RAM. Q: I changed the IP address of the controller, but I forgot it. How do I reset my controller? Answer: Using a paper clip, push and hold the reset button on the front of the controller and release after 15 seconds. The default IP address of the controller is 192.168.10.200. The default user name and password is "admin". 42