TRENDnet TEW-ASAK Quick Installation Guide - Page 4
knife or box cutter.
 |
UPC - 710931502961
View all TRENDnet TEW-ASAK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
4. Flip over the camera housing and remove the rubber stoppers and washers. 5. Remove the circuit board from the camera enclosure by unscrewing the two screws. Save these screws. You will need to use these screws later. 6. Take a power cord and cut it using a wire cutter. Cut it near the female end of the power cord. Note: The power cord is not included with 15AH-28B. 7. Cut the rubber insulation using a knife or box cutter. 3 English
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11
-
12
-
13
-
14
-
15
-
16
 |
 |
English
3
5.
Remove the circuit board from the
camera enclosure by unscrewing
the two screws. Save these
screws. You will need to use these
screws later.
4.
Flip over the camera housing and
remove the rubber stoppers and
washers.
7.
Cut the rubber insulation using a
knife or box cutter.
6.
Take a power cord and cut it using
a wire cutter. Cut it near the female
end of the power cord. Note: The
power cord is not included with
15AH-28B.