TRENDnet TPL-406E2K User's Guide - Page 10

TRENDnet User's Guide To change the default encryption key between two Powerline adapters: Note: Use the Sync button procedure below if you are connecting TRENDnet Powerline models TPL-303E, TPL-304E, TPL-308E, TPL-309E, TPL-311P, TPL-406E, or TPL-407E. If you are connecting to other TRENDnet Powerline models, please refer to the Appendix on page 23 for using the correct Sync button procedure. 1. Verify that all Powerline adapters are already installed and connected using the default encryption key, see "Installing your Powerline Adapters" on page 5. 2. Push and hold the Sync button on one of the Powerline adapters for 3 seconds and release it. The Power (PWR) LED will start blinking. This will initiate the Sync process and generate a random encryption key on the first Powerline adapter. 3. Within 2 minutes, push and hold the Sync button on the other Powerline adapter for 3 seconds and release it. The Power (PWR) LED will start blinking. This will negotiate a connection between both Powerline adapters using the new encryption key. All LEDs will turn off and turn back on and the Powerline (PL) LED will turn on the when adapters are connected. TPL-406E / TPL-406E2K Add adapters using the Sync button If you have changed the default encryption key assigned to your Powerline adapters, additional adapters will not automatically connect to your Powerline network after they are plugged into a wall power outlet. For any additional adapters, you will need to reconfigure any additional Powerline adapters that you add to use the encryption key of your existing Powerline network. © Copyright 2012 TRENDnet. All Rights Reserved. 8