TRENDnet TU-ET100plus Manual - Page 5
Installation
 |
View all TRENDnet TU-ET100plus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
INSTALLATION Precaution Before the installation, make sure the USB port exists in your computer and is enabled. To check this, go to My Computer?Control Panel?System. Open the Device Manager tab. If the Universal Serial Bus controller device is found, it means your USB port is installed and enabled. If not, either no USB port is installed or the USB bios is not properly enabled. In this case, consult your computer dealer for USB support. Getting Hooked Up 1. Locate the USB host port of your system. Align the USB connector toward the USB host port, push evenly and steadily until it is seated. - 3 -
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
- 3 -
INSTALLATION
Precaution
Before the installation, make sure the USB port
exists in your computer and is enabled. To check
this,
go
to
My
Computer
?
Control
Panel
?
System
. Open the Device Manager tab.
If the
Universal Serial Bus controller
device is
found, it means your USB port is installed and
enabled. If not, either no USB port is installed or
the USB bios is not properly enabled. In this
case, consult your computer dealer for USB
support.
Getting Hooked Up
1. Locate the USB host port of your system.
Align the USB connector toward the USB host
port, push evenly and steadily until it is seated.