TRENDnet TW100-W1CA Manual - Page 33

TRENDnet TW100-W1CA Manual

Get TRENDnet TW100-W1CA PDF manuals and user guides View all TRENDnet TW100-W1CA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Figure 22 5. When the following screen appears, power on the device. Figure 23 6. Expect to wait for a few seconds before the upload program detects the device. Once the device is detected, the program will start uploading the firmware automatically. The upload process takes a couple of minutes. After the upload is completed, this device will automatically restart. Note: DO NOT interrupt the firmware uploading process. 7. When the upload finished, the screen should look like Figure 24 below. Figure 24 If any error message appears , check the cable connection and make sure that you have selected the correct COM port, then perform the upgrade again. - 29 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
- 29 -
Figure 22
5.
When the following screen appears, power on the device.
Figure 23
6.
Expect to wait for a few seconds before the upload program detects the device. Once the
device is detected, the program will start uploading the firmware automatically. The
upload process takes a couple of minutes. After the upload is completed, this device will
automatically restart.
Note: DO NOT interrupt the firmware uploading process.
7.
When the upload finished, the screen should look like Figure 24 below.
Figure 24
If any error message appears, check the cable connection and make sure that you have
selected the correct COM port, then perform the upgrade again.