Thermador CIT304TM Installation Instructions - Page 9

Code or Canadian Electrical Code and all local codes and ordinances. Attach flexible conduit to the junction box. Connect the lead wires to the junction box supply wires in proper phase: ▯ black (L1) to black ▯ red (L2) to red ▯ green or bare to ground    1 House power supply cord 2 Black wire 3 Junction box 4 Cooktop power supply cord 5 Grounded green or bare cable 6 Certified UL connector 7 Red wire If the cooktop is installed and connected as specified above, it will be grounded in compliance with the National Electrical Code. Check the Installation 9 CAUTION Before you plug in an electrical cord or turn on power supply, make sure all controls are in the OFF position. Remove everything from the cooktop surface including stickers. Clean cooktop surface with cooktop cleaning cream. Switch on the circuit breaker. Verify that elements function properly. Customer Service Contact Customer Service if your appliance needs repair (see phone number below). Our Customer Service will be happy to provide you with information about an authorized servicer near you. Model (E) number and FD number When you contact Customer Service, please have the Model (E) number and the FD number for your appliance available. You can find the rating label with these numbers: ▯ in the appliance pass ▯ on the underside of the appliance You can also find the Model (E) number by accessing the basic settings of the cooktop. You can check the Customer Service index (CSI) and the FD number in the basic settings. Please refer to the section on "Basic Settings" in your Use and Care manual. ZZZWKHUPDGRUFRP 0DLQ6WUHHW6XLWH ,UYLQH&$ 9