Thermador CIT304YB Installation Instructions - Page 5

Before you begin 2 Before you begin Before you begin Read these instructions before you begin to install your appliance. 2.1 Parts included After unpacking all the parts, check for any damage in transit and for completeness of delivery. 2.2 Tools and parts needed Prepare these tools and accessories before you start to install your appliance. ¡ Pencil ¡ Measuring tape ¡ Cross head screwdriver ¡ Drill with bit 1/4" (6 mm) ¡ Jigsaw Note: Additional materials may be necessary for installation in solid surface countertops. Contact the countertop manufacturer. 2.3 Cabinet requirements Ensure that the cabinetry at the installation location meets the requirements for a safe installation. ¡ The distance from the top of the cooktop to the bottom of cabinets above must be a minimum of A=30" (762 mm). Before you begin en-us ¡ This distance can be reduced to A=24" (610 mm) when the bottom of the wood or metal cabinet is protected by not less than ¼" (6.35 mm) flame-retardant millboard covered with not less than no. 28 gauge sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. ¡ Verify that unprotected cabinets above the cooktop are a maximum of B=13" (330 mm) deep. Installation in combination with other products Both products must be installed according to their specific product installation instructions. Installing a cooktop over ovens and microwaves: Only certain models may be installed over an oven or a microwave. Verify the Approved Combination Guide supplied with these instructions for approved installation combinations. Both products will have a label stating Approved Combination Guide. Installing a range hood or a microwave hood above the cooktop: Follow the range hood or microwave hood installation instructions for dimensional clearance above the cooktop surface. 2.4 Countertop requirements Ensure that the countertop into which the cooktop is to be installed meets these requirements for a safe installation. WARNING To reduce the risk of ignition of surrounding combustible materials, install at least 2" (51 mm) from both sidewalls and the rear wall. ¡ The countertop must be level and horizontal. ¡ The stability of the countertop must be maintained after the cut-out has been made. ¡ Solid surface countertops often require special installa- tions. For example, heat-reflective tape and rounded corners may be necessary. ¡ Contact the countertop manufacturer for instructions specific to your countertop. Prepare installation space 3 Prepare installation space Prepare installation space Create the cutout in the countertop according to the instructions. General countertop requirements: ¡ The angle of the cut surface to the countertop must be 90°. ¡ With multi-layered countertops, secure strips laterally in the cutout if necessary. ¡ After creating the cutout, remove all shavings. ¡ Seal the cut surfaces in a heat- and water-resistant manner. ¡ Observe the minimum distance between device under- side and cabinet surfaces of ⅜" (10 mm). ¡ The countertop into which the cooktop is installed must be heat-resistant up to 140° F (90 °C). ¡ The countertop into which the cooktop is installed must be at least 20 mm) thick. 5