Thermador CIT367YGS Installation Instructions - Page 8

en-us Electrical connection 4.2 Securing the cooktop to the countertop The cooktop must be secured from below using the holddown brackets provided, so it does not slip. 1. Place the cooktop face down on a soft underground. 2. Attach the hold-down brackets to the underside of the cooktop with the provided short screws . Do not tighten the screws. Electrical connection 5 Electrical connection Electrical connection Read these instructions to safely connect your appliance to the electrical supply. 5.1 Electrical requirements Ensure that the following general requirements are met. ¡ You can find the rating plate with the electrical specifi- cations on the underside of the appliance. → "Rating plate location", Page 9 ¡ The junction box must be located within 3 feet of the cooktop connection. It should be easily accessible for service purposes. 3. Rotate the hold-down brackets so that the appliance can be placed in the cutout. 4. CAUTION Do not let the cooktop drop into place. ▶ Make sure that the cooktop is supported along the edges when carefully placing it into the cutout. Turn the cooktop over and place it carefully into the countertop cutout. 5. Insert the clamping screws into the hold-down bracket and secure the cooktop to the countertop . Protect delicate countertops by placing a wooden disk underneath. 6. Tighten the hold-down bracket screws on the cooktop underside. max. 2¾" (69 mm) + fitting/conduit 1" (25 mm) min. 1" (25 mm) air clearance approx. 12" (300 mm) junction box flexible conduit approx. 3 ft. (900 mm) Power supply All models must be connected with the included 39" (1 m) flexible conduit. Models CIT304YB CIT304YM CIT365YB CIT367YG CIT367YGS CIT367YM CIT367YMS 240 V AC, 3-wire, 60 Hz system: circuit breaker 30 A 30 A 50 A 50 A 50 A 50 A 50 A 208 V AC, 3-wire, 60 Hz system: circuit breaker 30 A 30 A 50 A 50 A 50 A 50 A 50 A 5.2 Connecting electrical supply WARNING Before installing, turn power OFF at the service panel. ▶ Lock service panel to prevent power from being turned ON accidentally. Note: If the cooktop is installed and connected as specified here, it will be grounded in compliance with the National Electrical Code. 1. Install a suitable junction box (not furnished). The branch-circuit breakers ampacity, the wire sizes and the connections must conform to the requirements of the National Electrical Code or Canadian Electrical Code and all local codes and ordinances. 8