Thermador KBUIT4855E Design Guide - Side-by-Side Refrigeration - Page 6

REFRIGERATION - SIDE-BY-SIDE SIDE-BY-SIDE CUSTOM PANELS TOP GRILLE PANEL - ROUTING REqUIREMENTS Top and bottom edges of the top panel should be edge routed 1/2" (1.3 cm) and 3/8" (9.5 mm), respectively. Both ends should be edge routed 7/8" (2.2 cm) as shown. ¹⁄� " (6.35 mm) max. Top Grille Top Grille ¹⁄� " (6.35 mm) max. 2.2 cm) 2.2 cm) NOTE: When creating a panel with face detail, the offsets will be hidden and must be accounted for in order to center the detail in the top grille. ¹⁄� " (1.3 cm) min. ¹⁄� " (6.35 mm) max. Top Center face detail between offsets DOOR PANELS - ROUTING REqUIREMENTS If an extended handle kit is used (EXTHANDSXS), then routing the handle side of the panels is not required. If the standard handle is used, route the entire handle side of both panels 3 1/4" (8.25 cm) to allow for finger clearance. Then route the other sides 1" (2.54 cm). STANDARD HANDLE - TOP VIEW 3¹⁄� " (8.25 cm) min. Hinge Side ¹⁄� " (6.35 mm) max. Door Panel Door Panel Handle 2" (5 cm) min. DOOR PANEL - SIDE VIEW 1" (2.54 cm) Panel ¹⁄� " (1.3 cm) min. ¹⁄� " (6.35 mm) max. ³⁄� " (9.5 mm) min. Bottom ¹⁄� " (6.35 mm) max. 1.800.735.4328 | THERMADOR.COM 265