Thermador MB30WP Installation instructions - Page 9

Flush installation 7RSYLHZ 6LGHYLHZ FOHDWV  ʎ&¼ʚOHDWV  ʎ&¼ʚOHDWV  OXGVHKSLWQKVHW  é  RSHQLQJ FXWRXW KHLJKW   ê ë é  IOXVK FXWRXW KHLJKW é  EDVHSODWH 0HDVXUHPHQWVLQLQFKHVPP Flush installation also requires: ▯ two side cleats to be attached inside the cabinet frame, recessed from the front ▯ a 5/16" (8 mm) baseplate underneath the unit body. Electrical Installation The model stated on the front cover is rated at 120V AC, 60 Hz and uses a NEMA 5-15 plug to connect to a dedicated 120 V microwave circuit. Model MB30WP Connection NEMA 5-15 Circuit Requirements 120 V, 15 Amps 60 Hz Electrical Requirements: ▯ a three prong grounded outlet ▯ 120 V, 60 Hz, AC only ▯ 15 Amp electrical supply with a fuse or a circuit breaker This product must be connected to a supply circuit of the proper voltage and frequency. Wire size must conform to the requirements of the National Electric Code or the prevailing local code for this rating. The power supply cord and plug should be brought to a separate 20-amp branch circuit single grounded outlet. The outlet box should be located in the area behind the appliance (see section Cabinet Dimensions). The outlet box and supply circuit should be installed by a qualified electrician and conform to the National Electrical Code or the prevailing local code. The voltage used must be the same as specified on the data plate of this microwave oven. Using a higher voltage is dangerous and may result in a fire or oven damage. Using a lower voltage will cause slow cooking. The manufacturer is not responsible for any damages resulting from the use of the oven with any voltage other than specified. 9