Thermador POD302RW Installation instructions - Page 12
Reinstalling Oven Doors with Bottom, Hinge
View all Thermador POD302RW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
1. The unit and its bottom packaging (pallet) should be positioned close to and in front of the cabinet opening prior to beginning to lift the unit into place. Reinstalling Oven Doors with Bottom Hinge To replace the oven door: 1. Holding the door firmly in both hands, grip it on either side. Do not grip by the handle. 2. Tilt the door back slightly towards you until it opens about 7" at the top. 2. Lift or slide unit into the cabinet cutout without allowing the unit base to contact the flooring. 3. Guide the unit straight back into the cabinet cutout. Push the unit straight in until the oven trim is about 2 inches from being flush with cabinet wall. Be careful not to crimp the flexible conduit between the oven and the cabinet back wall. If necessary, guide the flexible conduit into the wall or cabinet access hole so it doesn't prevent the unit from being pushed all the way into the cabinet opening. The oven should be straight and level, not crooked. 4. Push the unit all the way back into the cabinet cutout until the front edge of the unit is flush with the front of the cabinet. 5. Install the supplied screws through the tap holes in the trim (2 screws for single ovens, 4 screws for double/ combo ovens). It is recommended to drill pilot holes for the trim screws. 3. Slide the hinges into the slots as far as they will go and then lower the door straight down. The angle of the door may need to be adjusted slightly to allow the hinges to engage properly and the door to lower into place. The door should lower about 3/4" and stop. If not, the hinges have not engaged properly and the door could fall if it is released. 4. Lower the door into the fully open 90° position. If the door will not lower all the way to the 90° position, the hinges are not correctly seated. The door should be straight, not crooked. To ensure the door and oven function properly, the screws should be installed on the face of the side trim for traditional bottom hinge doors and on the side of the side trim for side hinge doors. 6. Replace the oven door(s) according to the following instructions. 5. Push the levers on both the hinges up and forward until they are locked into the slot, flush with the front of the oven body. 6. Close the door gently. It should close all the way. Gently open and close the door several times to be sure it is correctly installed and securely in place. 12
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80
-
81
-
82
-
83
-
84