Thermador T18ID905LP Instructions for Use - Page 9
Before using for the first time, Water connection, Electrical connection
View all Thermador T18ID905LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Before using for the first time 1. Remove information material, adhesive tape and protective foil. 2. Clean the appliance. ~ "Cleaning" on page 24 Water connection 9 CAUTION ■ Installation and connection of the appliance must be carried out by authorized technicians according to the installation instructions supplied. ■ To avoid damage to the appliance and to ensure its proper functioning, it should only be connected to a drinking water system. ■ To avoid water damage, a shut-off valve must be installed. Water pressure of drinking water system 9 CAUTION To avoid damage to the appliance, a pressure relief valve must be installed between the drinking water connection and the tubing, should the water pressure exceed the maximum value. Note: If the water pressure is too low, this will impair the relevant functions of the appliance. ■ Min. 0.2 Mpa (2 bar / 29 psi) ■ Max. 0.8 Mpa (8 bar / 116 psi) Installation and connection en-us Electrical connection 9 CAUTION Do not connect the appliance to electronic energy saver plugs. Note: You can connect the appliance to mainscontrolled and sine-controlled inverters. Mains-controlled inverters are used for photovoltaic systems which are connected directly to the national grid. Sine-controlled inverters must be used for isolated applications. Isolated applications, e.g. on ships or in mountain lodges, are not directly connected to the national grid. 1. After installing the appliance, wait at least 1 hour before connecting it to prevent damaging the compressor. 2. Check that the outlet was installed according to the regulations and complies with the requirements. Requirements for outlets Outlet with Protective conductor Fuse 110 V ... 120 V 60 Hz 10 A ... 16 A Maximum simultaneous load Appliance 6 A 3. Connect the appliance to an outlet near the appliance. The outlet must also be freely accessible following installation of the appliance. If free access is impossible, an all-pole isolating switch must be integrated into the permanent electrical installation according to the installation regulations. 9 WARNING RISK OF ELECTRIC SHOCK! Never use multiple outlets, extension cords or adapters. The appliance must be grounded correctly. Never cut through or remove the power cord's third conductor (grounding conductor). 9 WARNING RISK OF ELECTRIC SHOCK! If the power cord is too short, never use multiple outlets or extension cords. Instead, please contact customer service. 9
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80
-
81
-
82
-
83
-
84
-
85
-
86
-
87
-
88
-
89
-
90