Thermador T36IB70NSP User Manual - Page 21
Resetting, factory settings, Water, filter
View all Thermador T36IB70NSP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Resetting factory settings Recommended after a change of owner. Water filter d WARNING d To avoid serious illness or death, do not use water that is microbiological or chemical unsafe or of unknow quality without adequate disinfection or other treatment before or after use of filter. q Simultaneously hold down the SETUP and ALARM OFF buttons for 3 seconds. If the factory settings are reset: - an appliance which is switched off switches on, - the Super function switches off, - settings changed in Setup mode are reset to factory settings. Exchanging the filter17. d CAUTION d - After installing a new water filter always discard the ice production of the first 24 hours after swichting on the icemaker. - If ice has not been used for a prolonged time, discard all ice cubes in the bin and discard the ice production of the next 24 hours. - If appliance or ice was not actively used for several weeks or months or ice cubes have an unpleasant taste or odor, change water filter. - Air trapped in system may cause water and cartridge to eject. Use caution when removing. - The filter should be changed at least every 6 months. If the following display is indicated: To purchase an "UltraClarity" replacement water filter contact your local dealer or call 1-800-578-6890 . If the following display is indicated: - The filter has to be changed immediately. 1. Rotate the filter cap on the base panel by 90-180° in an antiĆclockwise direction. 2. Pull the used filter cartridge out of the appliance. 3. Remove the cap from the used filter. Take a new filter cartridge out of the packaging and remove the protective cap. 4. Push the cap onto the new filter cartridge. The age of the filter is close to the maximum life time. Order a new "UltraClarity" water filter. 21