Thermador VCIN48JP Installation Instructions - Page 11
Assembly of the Transition
View all Thermador VCIN48JP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Assembly of the Transition 10" (254 mm) Duct 10¼" (260 mm) 1" (25.4 mm) screw x2 1213/16" (325 mm) 3 5/16" (84 mm) 17½" (445 mm) Figure 2: Transition Dimensions 4 5/16" (502 mm) 21¾" (552 mm) 11¼" (286 mm) 17½" (444 mm) Figure 4: Transition Centerline 1. A minimum height clearance of 10¼" (260 mm) is needed above the hood for transition mounting. 2. Remove transition from inside of hood. Discard brackets attaching transition to the inside of hood. 3. Align mounting holes at base of transition with the mounting holes of the 1/2" (13 mm) flange located at the top or rear of the hood. 4. Fasten transition to hood using two (2) 1" (25.4 mm) sheet metal screws included with hood. 5. Seal connection between transition and hood with aluminum tape. DO NOT use duct tape. 6. Remove tape holding damper closed. Figure 3: Transition Cutout English 9