Thermador WDC30E User Manual - Page 9

Beep Hot Surface Indicator (H) Off Pad Signal Light Temperature Pads Timer The control panel beeps to confirm an entry. The timer beeps five times when the time has elapsed. The Hot Surface Indicator appears in the display when the glass bottom of the warming drawer is hot. Do not touch the inside of the drawer during this time. The H disappears when the drawer has again reached a safeĆtoĆtouch temperature. If the warming drawer is open when it is connected, an H will appear. This is the indicator for Hot Surface", even if the glass plate is cold. After closing the drawer, the H will disappear if the glass is cold. The H will not disappear if the glass plate is still hot. Use this pad to switch off the warming drawer. The signal light turns on when the drawer is in use. It is flashing when the drawer is open, and indicates when the drawer is closed. The temperature pads control the temperature of the drawer bottom. Table1: Temperature Pad Settings Setting LOW MED (Medium) HIGH PLATES Surface Temperature of Drawer Bottom 140º F 170º F 200º F 170º F + convection See Table Temperature Recommendations" for recommended settings. The timer can be set for any increment of 5 minutes. The minimum time is 5 minutes and the maximum is 5 hour. During use, the timer automatically stops counting down when the drawer is opened. It begins again when the drawer is closed. When the time has elapsed, the timer beeps five times and the drawer automatically turns off. Changing the Timer Use the + or Ć pad to change the time. The appliance will only heat up if the drawer is closed correctly. The signal lamp indicates. 9