Timex T307S Operation Manual - Page 10

Listening and Sleeping to the Radio Operating the Radio 1. Press the N Power/Sleep Button once to turn on the radio. Note: If the N Power/Sleep Button is pressed more than once, the unit will enter the sleep mode, with the radio operating on a timer. See Sleeping to the Radio Using the Timer for more information about this feature. 2. Press the L Mode/DST Button to select the AM band or one of the two FM bands. The Radio Band Indicator will show which frequency is in use. 3. Press the 1 Reverse and 6 Forward Buttons to tune into a radio station. To scan the stations, hold a button for about three seconds. The radio will rapidly advance to the next strong signal. 4. You may also use the M Memory Set Buttons to select a preset radio station. See the Programming Radio Station Memories section for instructions on programming radio station settings. 5. Rotate the O Volume Thumbwheel to adjust the volume level. 6. Press the 3 Off/Reset Button to turn the power off. Programming Radio Station Settings This Alarm Clock Radio features a total of 18 programmable radio settings: 12 FM stations and six AM stations. These allow you to preset your favorite stations and access them quickly. 1. Press the N Power/Sleep Button once to turn on the radio. 2. Press the L Mode/DST Button to select a radio band. The AM/FM Radio Indicator will show which band is in use. 3. Press the 1 Reverse and 6 Forward Buttons to find a station to program into the memory. 4. When you have reached the station you wish to program, press and hold one of the six M Memory Set Buttons until you hear a beep. The radio station has now been programmed into that preset slot, and you can reach the station by pressing its M Memory Set Button while the radio is turned on. 5. Follow the above instructions to continue programming radio station settings into the memory. You can save a total of 18 stations using the three bands. 6. To edit a setting, enter a different radio station as an existing M Memory Set Button. This overrides the original setting. Antenna Information and Adjustment FM - Extend the FM wire antenna to its full length and vary the direction to its strongest signal. AM - The AM bar antenna is located inside the cabinet. Rotate the unit until you find the strongest AM signal. Last Station Memory The tuner always remembers the last station selected before the radio was switched off, and automatically selects the station again when the radio is turned on. 10