Tineco FLOOR ONE S3 Instruction Manual - Page 17

EN Voice Prompt (Contents may vary, please in kind prevail.) Status Battery level: 10~20% Battery level: 0~10% WiFi network connected Clean Water Tank is empty Dirty Water Tank full or channel blocked Dirty Water Tank is full during self cleaning Dirty sensor Dirty HEPA filter Brush roller is tangled Brush roller not installed Too much wear of brush roller Shutting down (takes 3s to shut down) Power is off Start charging Need self cleaning Appliance not on the charging base Battery insufficient for self-cleaning Sufficient battery to start self cleaning Cleaning brush roller Cleaning debris channel Auto detecting Deep cleaning Self-cleaning completed Self-cleaning stopped Clean with cleaning solution by default Clean with water only Auto mode by default Switch to Max mode Voice prompts on Voice prompts disabled Reminder Low battery Low battery, please charge Network connected Clean Water Tank empty, please refill water and cleaning solution Clean the Dirty Water Tank or the debris channel Dirty Water Tank full, please empty Please begin self-cleaning cycle Please clean the filter in Dirty Water Tank Please clean the brush roller Please install the brush roller correctly Please replace the brush roller Shutting down Power off Charging has commenced. Auto-detecting whether to run self-cleaning cycle Please begin self-cleaning cycle Please place appliance on the charging base Low battery, start charging Start self cleaning Cleaning brush roller Cleaning debris channel Auto detecting Deep cleaning Self-cleaning cycle complete. Please clean Dirty Water Tank Self-cleaning cycle stopped. Please clean Dirty Water Tank Clean with cleaning solution Clean with water only Auto Mode Max Mode Voice prompts on Voice prompts disabled 15