TomTom 9M00.002 Remote Control User Guide - Page 2

Remote control

Get TomTom 9M00.002 - GPS Receiver Remote Control PDF manuals and user guides
UPC - 636926017183
View all TomTom 9M00.002 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

EN Remote control Rcoenmtrootle Important: This TomTom product is Bluetooth enabled. Please note that in certain environments such as hospitals or airplanes, you are required to switch off Bluetooth, on all electronic devices. Inserting the batteries 1. Hold the sides of the remote control and press the latch on the back of the device. The keypad lifts out from the back of the device, as shown in the diagram. Take care not to drop the keypad. 2. Place the batteries in the remote control. Make sure you put the batteries in the correct way round, as shown on the remote control. 3. Replace the battery cover and press any button to switch on your remote control. Your remote control starts searching for your TomTom GO. Note: If you do not use your remote control for 20 seconds, it goes into power saving mode. If you do not use your remote control for one hour, the remote control switches off completely. Press any button to switch your remote control on. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
EN
Remote control
4
Remote
control
Important
: This TomTom product is Bluetooth
enabled. Please note that in certain environments
such as hospitals or airplanes, you are required to
switch off Bluetooth, on all electronic devices.
Inserting the batteries
1.
Hold the sides of the remote control and press the
latch on the back of the device.
The keypad lifts out from the back of the device,
as shown in the diagram. Take care not to drop
the keypad.
2.
Place the batteries in the remote control. Make
sure you put the batteries in the correct way
round, as shown on the remote control.
3.
Replace the battery cover and press any button to
switch on your remote control.
Your remote control starts searching for your
TomTom GO.
Note
: If you do not use your remote control for 20
seconds, it goes into power saving mode.
If you do not use your remote control for one hour,
the remote control switches off completely.
Press any button to switch your remote control on.