Toro 20330 Operation Manual - Page 7
Starting the Engine, Using the Self-propel Drive
UPC - 021038203300
View all Toro 20330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Adjust the cutting height as desired. Set the front wheels to the same height as the rear wheels. Note: To raise the mower, move all the cutting height levers rearward. To lower the mower, move all the cutting height levers forward (Figure 9). Starting the Engine 1. Hold the blade control bar against the handle (Figure 10). 1. Raise the mower Figure 9 2. Lower the mower Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches (35 mm); 1-3/4 inches (44 mm); 2-1/8 inches (54 mm); 2-1/2 inches (64 mm); 2-7/8 inches (73 mm); 3-1/4 inches (83 mm); 3-5/8 inches (92 mm); and 4 inches (102 mm). 1. Blade control bar Figure 10 2. Recoil start handle 2. Pull the recoil start handle lightly until you feel resistance, then pull it sharply. Allow the rope to return to the handle slowly (Figure 10). Note: If the mower does not start after several attempts, contact an Authorized Service Dealer. Using the Self-propel Drive To operate the self-propel drive, squeeze the self-propel drive bar (Figure 11) toward the handle and hold it. Figure 11 1. Self-propel drive bar To disengage the self-propel drive, release the self-propel drive bar. 7