Toro LD6 Operation Manual - Page 7

Off Use this dial position to turn off watering, such as when it is raining or you don't want watering. As long as the dial is in the OFF position, watering programs will not be activated automatically. The OFF position is also used to terminate all running program A or B watering cycles, whether manual or automatic. IV. Manual Programming Manual Program Cycle Use this feature to manually start a program. For example, this can be used to start a program an extra time on a particularly hot day. 1. Set the dial to the MANUAL PROGRAM CYCLE position. 2. Select program A or B. 3. Press the + button to select manual program cycle. 4. Press the 4 button until the desired starting valve is displayed. That valve and all subsequent valves in the selected program will water in sequence. 5. Return the dial to the RUN position to begin the manual watering cycle. Display shows MANUAL PROGRAM CYCLE A, program A or B, valve number A, and counts down the remaining run time for each active valve. 1. Set the dial to the OFF position. Valves currently watering will be turned off after dial is in OFF position for at least two seconds. All active programs are discontinued and watering is stopped. 2. To return controller to normal automatic operation, simply return dial to RUN position. Warning: In warm weather you may experience landscape damage if the dial is left unintentionally in the OFF position for extended periods of time. Always return the dial to RUN position if automatic operation is desired.